Description
The AZCO ACU-SERT™ CI-250 Inserter will automatically feed, cut and dispense sheets for your application. With an optional eye registration system, the unit will cut registered sheets, without the need of a printed eye mark. The use of material in roll form will save approximately 20% of the cost of the material, compared to using pre-cut sheets. With a roll, labor is reduced and operator error is eliminated. One roll can hold over 30,000 insertions and there is no need to continuously load a magazine, as done with pre-cut sheets.
The inserter feeds and cuts paper, film, foil, and label inserts up to 9 in/250 mm wide. Overwrapped coupons and leaflet pouches may also be fed from a fan-folded web. A 2-panel folding plow option is available to fold any web up to 6 in/160 mm wide in half, prior to delivery.
This unit can be a master or a slave to an existing line. Simple to use and integrate, and jam-free. Plug directly into 110 V AC, and supply a dry contact signal when ready to dispense the next sheet.
Options
Insert-fed verification signal
No-product sensor
Portable base
Folding plow
On demand digital printing
Benefits
Easy to mount either over or along side a production line
Operator keypad for easy setup
Simple to change outfeed angle from horizontal to 45 degrees down
Eliminates the need to hand place sheets
High productivity to 300 inserts per minute
Low maintenance sealed bearings, rotary cutter and permanent magnet unwind
High accuracy
Specifications
Power requirements: 110 V AC or 220 V AC, 10 amps
30 - 90 psi (2 - 6 bar) compressed air
Maximum rate: 300 cpm at 76mm/ 3"
Shipping weight: 68kg/150lbs.
Accuracy: +/-0.38mm/0.015" or 0.1% of cut length (whichever is larger)
English
简体中文
